Reasons Why Your Nissan Qashqai Key Fob Won't Work

The Qashqai has a distinct SUV-like feel due to its larger dimensions, and the ride on 19-inch wheels in Ti and ST-L models can be a bit spongy at times. The front tyres in the Qashqai may also lose grip on rough surfaces, and the CVT may occasionally display a wrist-flexing torque steering.

This is typically caused by dead batteries that can be replaced in a matter of minutes. Make sure that the replacement battery has the same voltage, size, and specification.

Water Damage

Water damage is among the most frequent causes for a Nissan keyfob to display the "key ID is wrong" message. The key fob comes with rubber seals that protect the chip inside. However, prolonged exposure to moisture could cause it to stop functioning properly. It is common to observe this happen if your key fob has been dropped into the water or a swimming pool. It can also occur when it is wet from the rain or soapy hands.

If your key fob has been exposed to water for a long duration, it might have to be cleaned with isopropyl ethanol or electronic cleaner. It could also require to be taken to an expert to repair or replace it.

If your key fob need to be replaced the process is easy. Make sure you have the right multipack (CR2032 3V). The front and rear cases using a flathead screwdriver. You'll have to remove the clips for retaining metal and push out the old battery, and then put in the new one. After reassembling the fob put the mechanical key back in position and ensure that it operates correctly. If it doesn't it is necessary to take it to your local Nissan dealer or an experienced Auto Key locksmith to replace the chip on the key. The chip is typically not damaged by water, so it isn't too costly.

Dead Coin Battery

Another reason that the reason your lost nissan car key Qashqai key fob may not work is that the battery in the coin has gone dead. They last for three to five years, but may fail over time in the event that the fob has been dropped frequently. You can replace the battery with a new one, but be sure that it's the same size and voltage as the original. If you install a new battery, it may cause the key to be assigned a wrong key ID. This could prevent it from being paired with your vehicle.

The best method to replace the coin battery in the nissan car key Qashqai Key Fob is to break it open using a small flat-head screwdriver. Push in the screwdriver in tiny notch at the bottom of the fob, and turn it around gently to separate the two parts of the key fob. Remove the old CR2025 battery and replace it with a brand new one, observing the position of the previous one inside the fob.

Examine the terminals for dirt or water damage prior to installing the new battery. If there is, wash the terminals with a small amount of isopropyl alcohol. You should also make sure the pole cables are plugged in correctly - they should be connected to the positive and negative poles of the battery, respectively.

Diagnostics of a fault

If your Nissan Qashqai's keys fob stops working after being exposed to pure rainwater or clean tap water it could be a sign there is an issue with the internal chip. A battery change won't solve this, and you'll need to buy a new key fob. If the key fob has stopped working after dropping it, it is likely that the chip inside was damaged. If you clean the chip using isopropylethanol and paper towels, then replace it in the key fob, you will generally get it working.

Key ID Incorrect is a typical error that can be seen on the dashboard of your car. This means that the vehicle is unable to recognize the key fob and not allow it to start the engine. The problem can be caused by a variety of things like water damage, undetectable problems in the circuitry of the key fob or RFID interference.

If the battery that powers 12 volts in your key fob dead or not providing enough electrical current, it will stop working. This will affect the remote keyless system as well as central locking in your nissan key repair Qashqai, as well as stopping you from starting the engine with the key fob (if equipped with Intelligent Key). If you're unable unlock or lock the door by hand, you should check the batteries on your key fob and make sure they're in good condition. Try replacing the battery to reset your transmitter.

Reprogramming

If the key fob has not been submerged in salt water, it should be able to come back to life after a quick rinse with clean water. You can also clean the electronic chip by using isopropyl or electronic cleaner. If none of these works then you might need to replace the key fob.

If your Nissan Intelligent Key is still not working, it could be an issue with the connection between it and your car. Start by pressing the ignition key, but without beginning the car. Continue to do this until the hazard lights flash twice. Then, turn the car off and take out the keys.

Open the fob compartment in your vehicle's fob compartment. It's usually located on a door jamb or the handle of the door for the driver. Find the small "program" button and press it. You will hear a chime after the process has been completed.

It's time to put your Intelligent Key to the test. Set your feet a distance from the vehicle, then hit all the buttons on it. If the lights flash and the horn sound it means the key is successfully linked to the nissan spare key replacement. You may also try testing the key in close proximity.